I can. When do you need it? How large is the plate? L x W x D? Drill press limits. Concerned that they are not thru holes....bottom of hole wud be concave. That Ok? If it needs to be flat you need a Forstner type bit/mill. You gonna tap them?
Why is a straight drill tricky? Wad I miss? > On May 1, 2017, at 5:54 PM, Gary Sitton via BVARC <[email protected]> wrote: > > Anyone know of anyone with the skills and tools to bore out four 1/2" holes > in an aluminum plate to 3/4". I'm very willing to pay. I considered a > step-bit or a straight drill but either is tricky, etc. This is for a base > plate on an antenna mast. The material is 6061-T6. > > Gary, K5AMH > > Sent with AquaMail for Android > http://www.aqua-mail.com > > > > _______________________________________________ > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Message delivered to [email protected] _______________________________________________ BVARC mailing list [email protected] http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Message delivered to [email protected]
