The patch seemed to work and brltty seems to be installed, but the display now doesn't work at all. How can I find out why?
On 7/17/16, Dave Mielke <d...@mielke.cc> wrote: > [quoted lines by Amanda Lacy on 2016/07/17 at 15:25 -0500] > >>What lines do I need to add in the makefile. > > I've attached a patch (brltty-make-1.patch) to this message that does it > properly. It's the fix that's been committed to the repository. If you apply > it > then you'll need to configure again. > > A simpler way, for now, is to remove these two lines from > Programs/Makefile: > > 966: $(INSTALL_PROGRAM) brltty-ktb$X $(INSTALL_PROGRAM_DIRECTORY) > 967: $(INSTALL_PROGRAM) brltty-tune$X $(INSTALL_PROGRAM_DIRECTORY) > > Note that you'll lose this change the next itme you configure. Applying the > > attached patch would really be the best route. > >>I assume one involves creating the brltty-tunes directory. > > No. brltty-tune (no s) and brltty-ktb are two new commands that are being > built. The problem was that they weren't included in the install dependency > > list. > > -- > Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of > God. > Phone: 1-613-726-0014 | Ottawa, Ontario | http://Mielke.cc/bible/ > EMail: d...@mielke.cc | Canada K2A 1H7 | http://FamilyRadio.org/ > _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: BRLTTY@mielke.cc For general information, go to: http://mielke.cc/mailman/listinfo/brltty
