[quoted lines by Mike Gorse on 2015/12/07 at 14:40 -0500] >If I install the unmodified udev rules file and connect my device, >then, without the patch, I get the crash. With the patch, it doesn't >crash in this way,
Thanks. The patch is now committed to the development stream. >but it still doesn't start up correctly, but I >think that that is basically a known issue in that the udev file >isn't intended to work unmodified with systemd. Ie, the systemd >documentation indicates that the Run directive is intended for a >short-running program, rather than a daemon, and it will kill the >program if it does not exit shortly after being started. The latest brltty service unit for systemd assumes that configure has autodetected the systemd development package. If configure isn't autodetecting systemd's development package then the older brltty service unilt needs to be used. I'll add it back to the repository and write a bit about this in README.Systemd. There are two possibilities for why configure isn't autodetecting systemd's development package. One is that you haven't installed it. The other is that it doesn't exist in your distributin because it's using an older version of systemd that doesn't yet support it. -- Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of God. Phone: 1-613-726-0014 | Ottawa, Ontario | http://Mielke.cc/bible/ EMail: d...@mielke.cc | Canada K2A 1H7 | http://FamilyRadio.org/ _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: BRLTTY@mielke.cc For general information, go to: http://mielke.cc/mailman/listinfo/brltty
