I just picked up a nice Atwater Kent 20 receiver (big box) and checked the
filaments of the tubes and they were OK...so far so good.
I have a Hickok 752A tube tester but there is no listing for these
tubes.....there is a 4 pin socket on the 752A in which the tubes will plug in
and fit.
I've seen where folks have tested these tubes on a TV7 (essentially same
circuit as 752A).
Any suggestions on how to test these tubes on my 752A?
Settings in particular??
Many thanks for any assistance...I'd like to get this fine receiver back up on
the air again.
73, Joe W2KJ
_______________________________________________
Boatanchors mailing list
[email protected]
https://puck.nether.net/mailman/listinfo/boatanchors
