Hello, with this, are you sure that you are actually editing the right config file? If you do a syntax error right at the beginning of the file, just putting garbage there, does it fail?
Maria On 2 December 2024 23:11:30 CET, LIU Chris via Bird-users <bird-users@network.cz> wrote: >Classified as: {Hitachi Rail - Public} > >I configured 4 bfd sessions like below, but 3 sessions are up, >I check many times, those 4 session seems no any difference. >I used birdc command to check >"birdc show bfd sessions session" >only 3 sessions, 1 session not list here. Why I configured, bird not take it. > >The stranger thing: even I comment out 3 sessions in conf file, just leave >one, kill bird daemon, restart bird, >Use birdc to check bfd sessions, still same, the 3 sessions are up, >It seems bird not read configuration file again. >What would the issue be ? > > ># Bidirectional Forwarding Detection (BFD) >protocol bfd BFD_CTI { > interface "*" { > min rx interval 500000 us; > min tx interval 500000 us; > idle tx interval 1500000 us; > multiplier 5; > }; > neighbor xx.xx.xx.xx local yy.yy.yy.yy; > neighbor a.b.c.d local e.h.i.j; > neighbor h.i.j.k local o.p.q.r; > neighbor s.t.a.b local u.w.u.j; >} > >Chris LIU > > >{Hitachi Rail - Public} -- Maria Matejka (she/her) | BIRD Team Leader | CZ.NIC, z.s.p.o.