Hello,
I configure a VTI interface with 'ip link add vti0 type vti local
aa.bb.cc.dd remote aa.bb.cc.de'
# bird --version
BIRD version 1.6.4
# ifconfig vti0
vti0 Link encap:UNSPEC HWaddr
C0-A8-03-03-00-00-00-00-00-00-00-00-00-00-00-00
inet6 addr: fe80::5efe:c0a8:303/64 Scope:Link
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1364 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:1 dropped:0 overruns:0 carrier:1
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:252 (252.0 B)
I configure bird with a static device route through that interface:
...
protocol device {
scan time 10; # Scan interfaces every 10 seconds
}
protocol direct testD {
interface "*";
}
protocol static testS{
route 10.20.0.0/24 via "vti0";
}
...
This route is never set unless I configure an IP address on the VTI
interface. If I repeat the same steps and use Quagga instead of Bird then
route is set.
Am I missing something in the configuration?
Best regards
Alexander Velkov
