Hello!
If you want to export these routes via OSPF3, it should be enough to add
the interfaces as stub:
interface "eth5" { stub; }
where "eth5" is the interface that creates the route you need to export
via OSPF3.
(Writing without looking into doc, the syntax may be slightly different.)
MQ
On 11/25/2016 04:24 PM, Eric Vyncke (evyncke) wrote:
> Ondrej,
>
> But grep'ing for RTN_LOCAL in the code, I have also tried this but then the
> route is marked 'unreachable' and I cannot import it to be exporting in
> OSPFv3 (which is my goal actually).
>
> Thanks for confirming that I was looking in the right direction ;-)
>
> -éric
>
> On 25/11/16 15:46, "Ondrej Zajicek" <santi...@crfreenet.org> wrote:
>
> On Fri, Nov 25, 2016 at 11:39:32AM +0000, Eric Vyncke (evyncke) wrote:
> > Hello,
> >
> > I am trying to import 'local' routes from the kernel into Bird without
> any success...
> >
> > The route is installed as: "/sbin/ip -6 route add local
> 2001:db8:cafe:babe::/64 dev lo" (it allows the host to reply/answer to any
> address in this prefix :-))
>
> Hello
>
> Routes in table 255 have special type (RTN_LOCAL, RTN_BROADCAST ...) and
> these route types are unsupported by BIRD.
>
> You could import them as unreachable routes by compiling BIRD with
> attached patch.
>
> Also note that routes with 'proto kernel' are ignored, byt that is
> probably not relevant to your case, just to other routes in table 255.
>
> --
> Elen sila lumenn' omentielvo
>
> Ondrej 'Santiago' Zajicek (email: santi...@crfreenet.org)
> OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net)
> "To err is human -- to blame it on a computer is even more so."
>
>
>
