Re: How to export address from loopback via BGP

Jamie Panagos Tue, 11 Nov 2014 09:02:37 -0800

Hi Eugene
       Do you have the following configured?


# Scan the device for routing changes every 20 seconds, this is required
for BIRD to see
# the direct routes and the static default
protocol device {
        scan time 10;
}

If not, that will prevent direct routes from making it into the table.


Thanks,

Jamie Panagos
Managing Principal Content Operations Engineer
Time Warner Cable
12101 Airport Way
Broomfield, CO 80021
Office: 720-279-2745
Cell: 303-718-7701
Email: jamie.pana...@twcable.com

On Tue, 11 Nov 2014, Ondrej Filip wrote:

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 11.11.2014 17:44, Eugene Prokopiev wrote:

Use protocol direct, as detailed in
http://bird.network.cz/?get_doc&f=bird-6.html#ss6.4


I tried to add:

protocol direct { interface "*"; }

but result was the same:

bird> show route export bgp1 bird>


And just 'show route' ?


This E-mail and any of its attachments may contain Time Warner Cable 
proprietary information, which is privileged, confidential, or subject to 
copyright belonging to Time Warner Cable. This E-mail is intended solely for 
the use of the individual or entity to which it is addressed. If you are not 
the intended recipient of this E-mail, you are hereby notified that any 
dissemination, distribution, copying, or action taken in relation to the 
contents of and attachments to this E-mail is strictly prohibited and may be 
unlawful. If you have received this E-mail in error, please notify the sender 
immediately and permanently delete the original and any copy of this E-mail and 
any printout.

Re: How to export address from loopback via BGP

Reply via email to