I have reloaded the configuration as well as restarted the bind9. The
simpliest workaround I see - bind IPv6 explicitly to the interface using
command "ip address add 2001:db8::1 dev eth0" and then I am able to use
2001:db8::1 for the named. But I would like to take advantage of using
AnyIP.
On 3/12/23 19:03, Darren Ankney wrote:
Just a quick question because I ran into this problem before... is it
possible that named was started before the ip was added?
On Sun, Mar 12, 2023 at 12:55 PM Serg via bind-users
<bind-users@lists.isc.org> wrote:
Hello, I am trying to bind named listener to an IPv6 from prefix which
is assigned to a system via AnyIP kernel feature - basically, it is done
by the following command: sudo ip -6 route add local 2001:db8::/32 dev lo.
To be able to use IPv6 from AnyIP prefix the following sysctl must be
applied: net.ipv6.ip_nonlocal_bind = 1
Having above, I am able to use any IP from AnyIP prefix in all software
but named refuses to create socket, which listens to that kind of an IP
address.
As an alternative approach I have tried to run with a configuration
"listen-on-v6 { any; }", but it does behave in a way I need - it binds
separate socket for each discovered IP address rather wildcard address
of [::].
Had anyone faced the same or similar issue?
--
Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from
this list
ISC funds the development of this software with paid support subscriptions.
Contact us at https://www.isc.org/contact/ for more information.
bind-users mailing list
bind-users@lists.isc.org
https://lists.isc.org/mailman/listinfo/bind-users
--
Visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from
this list
ISC funds the development of this software with paid support subscriptions.
Contact us at https://www.isc.org/contact/ for more information.
bind-users mailing list
bind-users@lists.isc.org
https://lists.isc.org/mailman/listinfo/bind-users
