Dear, thanks for your help. As I have shown above, I use two views with a TSIG key for each view, but the zone transfer doesn't work.
Please can you send me your Bind views configuration if you can, on master and slave sides? Thanks a lot again. Regards!!! El mié., 3 jul. 2019 a las 17:27, Sten Carlsen (<st...@s-carlsen.dk>) escribió: > > > On 03/07/2019 22.14, Grant Taylor via bind-users wrote: > > On 7/3/19 2:04 PM, Lightner, Jeffrey wrote: > > You have to use separate IPs for the separate views on the master and the > slave. > > > I thought you could use different TSIG keys to identify different zones > with a single IP at each end. > > Is that not the case? > > As far as I am aware the two views must use different keys, with the same > IP the key (or the view's ACL) is the only thing to distinguish between the > views. > > You can use the same IP for both views at least on the master, I have that > setup and have for a very long time seen it running without any problem. I > do not use keys but let view ACL do the work. > > > > > > _______________________________________________ > Please visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe > from this list > > bind-users mailing > listbind-us...@lists.isc.orghttps://lists.isc.org/mailman/listinfo/bind-users > > > _______________________________________________ > Please visit https://lists.isc.org/mailman/listinfo/bind-users to > unsubscribe from this list > > bind-users mailing list > bind-users@lists.isc.org > https://lists.isc.org/mailman/listinfo/bind-users >
_______________________________________________ Please visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list bind-users mailing list bind-users@lists.isc.org https://lists.isc.org/mailman/listinfo/bind-users
