Hi， Thanks for your reply, but I see in RFC 8365, there is description like this :
In section “9. Support for Multicast”: “The originating router's IP address field is set to the NVE's IP address.” In section “5.1.3. Constructing EVPN BGP Routes” : “The Next Hop field of the MP_REACH_NLRI attribute of the route MUST be set to the IPv4 or IPv6 address of the NVE. The remaining fields in each route are set as per [RFC7432].” It is confused that if the addresses described in above two places is the same ip address or not. So I am not confirm that there may be some situations where the originating router's IP address is not equal to bgp next hop. Or the IMET route construction in vxlan scenario is not follow the same rule as in mpls scenario(rfc7432) ? Thanks Yang Huang 发件人: Rabadan, Jorge (Nokia - US/Mountain View) [mailto:[email protected]] 发送时间: 2019年7月1日 14:51 收件人: huangyang (E) <[email protected]>; [email protected] 主题: Re: [bess] [Mail regarding rfc7432]Could you clarify which IP address we use to construct P2P tunnel for ingress replication. Hi, I think you should construct the ingress replication tunnels using the next hop of the IMET routes, otherwise you will have issues with inter-as model B scenarios. The received originating IP and next-hop at the ingress PE do not need to be the same. Thanks. Jorge From: BESS <[email protected]<mailto:[email protected]>> on behalf of "huangyang (E)" <[email protected]<mailto:[email protected]>> Date: Monday, July 1, 2019 at 8:46 AM To: "[email protected]<mailto:[email protected]>" <[email protected]<mailto:[email protected]>> Subject: [bess] [Mail regarding rfc7432]Could you clarify which IP address we use to construct P2P tunnel for ingress replication. Hi WG, In the charpter 11.2 of RFC 7432: 11.2. P-Tunnel Identification "...+ If the PE that originates the advertisement uses ingress replication for the P-tunnel for EVPN, the route MUST include the PMSI Tunnel attribute with the Tunnel Type set to Ingress Replication and the Tunnel Identifier set to a routable address of the PE." a routable address of the PE is not so strict. And does this mean we use the Tunnel Identifier to construct P2P tunnel for ingress replication, or we use the Originating Router's IP Address in the IMET route key, or they are equivalent meaning? And I see it use the BGP Next hop to construct P2P tunnel for BUM ingress relication in RFC8365, Should Originating Router’s IP Address, the IP address of BGP Next hop, Tunnel Identifier in PMSI, be the same IP address? Now, this may cause interact problems when it implements differently. Could you clarify this? Thanks. Brgds, Yang Huang
_______________________________________________ BESS mailing list [email protected] https://www.ietf.org/mailman/listinfo/bess
