Hi User PC, You did not need to install any drivers that require disabling driver signature verification. As a matter of fact you do not need to install any drivers on Windows 10. The instructions that you probably followed are not 100% correct. I know this because I ran into the same confusion when I first got my BBB a few months ago.
Basically, all you need to do is set your static IP address to 192.168.7.1. The beaglebone black has it's subnet set up so that the IP address range is 192.168.7.1 through 192.168.7.2. Obviously, with the BBB being ".2", your PC must be on ".1" Once you to this, try to connect again using firefox, it will go right through. Note that if you are using MAC or LINUX, your static IP should be 192.168.6.1, with the subnet mask on the BBB only allowing IP address ranges of 192.168.6.1 through 192.168.6.2. When you set up the static IP, make sure you do it for the beaglebone network card that shows up, not your PC's physical network card. If you installed any drivers, I would remove them. The new BBB boards do not require drivers. On Thursday, August 29, 2019 at 2:23:37 PM UTC-5, user pc wrote: > > Hi, I got BeagleBone Black Wireless. I connected it to my PC running > Windows 10 64-bit. After spending lots of time to find that I needed to > disable Driver Signature Verification, I installed the drivers successfully > from the E drive by running BONE_D64. After installation, I typed > 192.168.7.2 under Firefox and got the connection timeout error. Could you > please let me what to do to resolve this issue? > > Also, after I pressed the reset button, the 4 LEDs near the microusb > connector blinked. Then, E drive showed up on the screen. However, after a > minute or so, the E drive disappeared from Windows and all those four LEDs > were turned off. Is this normal? Why the E drive disappeared from Windows. > Could it be that the usb cable does not supply enough power to the board? > Should I use a 5VDC 2A to supply power source? > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/574c7c2f-7a39-4043-ad8f-2ec2168b634f%40googlegroups.com.
