On Wed, Nov 1, 2017 at 10:17 AM, William Hermans <[email protected]> wrote:
> > > On Wed, Nov 1, 2017 at 10:12 AM, William Hermans <[email protected]> > wrote: > >> >> >> On Wed, Nov 1, 2017 at 10:05 AM, Tracy Smith <[email protected]> >> wrote: >> >>> We have no P9expansion header. I’ve already discussed this with Robert >>> Nelson. We are using the AM3358 pins I sent previously. Any can using the >>> P9and this overlay will not work for our custom board. >>> >> >> Ok, good, that doesn't make a bit of difference at all. Those pin names >> in the overlay are just variables used by the file, and initially by cape >> manager. cape manager translates those variable names into addresses when >> the overlay file is compiled. >> >> Passed that, the software that is provided could stll use the Px header >> designation for the pins, and it'll still work fine if you're using >> something like universal IO + config-pin, so long as you all have not done >> something drastically different in your layout. I do recall that some >> devices can be done using multiple pin configurations, and one in fact is >> still like that with the beaglebone design as is. >> >> Anyway, I do not remember if CAN1 has the potential to be on different >> pins or not. Out of the processor. But working with the file I sent you a >> link to all that can easily be changed. >> > > Well technically, I'm not 100% positive on this. There could be hooks, etc > I'm not aware of, and I have not done this hands on personally. But so long > as you're using the same pins the bealgebone is using. It should work. > > Are you, or are you not using he same pins as the beaglebone for CAN1 ? > Another thing I did not consider is that it sounds like you could be using a completely different board file overlay for your hardware, at which point all bets are off. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CALHSORpUw6vhmD7CtNRhA1R1aL2zhkVcpXaELo%3DS%2BS%3DAL3057g%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
