Thanks that worked. stty -F /dev/ttyO5 57600 -echo
Thanks, Caleb Davis > On Oct 9, 2015, at 9:53 AM, Chris Green <[email protected]> wrote: > >> On Fri, Oct 09, 2015 at 07:04:15AM -0700, [email protected] wrote: >> I am seeing a similar issue. I am using a terminal program on my >> computer to send bytes to the BeagleBone over a usb-to-ttl converter. >> Each byte that I send from my PC is received correctly on the >> BeagleBone (seen via "catting" /dev/ttyO5 in my case) but I am seeing >> the BeagleBone respond with the same byte that I just transmitted. I > > That's what it's supposed to do! When you send characters they are > (normally) echoed back by the remote system, you don't output them > locally. You probaby want to set NOECHO or -echo on the program in > the PC that's sending the characters. > >> have double checked my wiring from my usb-to-ttl converter and >> everything is correct. Any ideas why this could be happening? >> Thanks >> On Friday, November 7, 2014 at 3:48:58 AM UTC-6, [email protected] wrote: >> >> [1][email protected] wrote: >>> [-- text/plain, encoding quoted-printable, charset: UTF-8, 79 >> lines --] >>> >>> I have resolved this now. Turns out it was a problem with the >> hardware >>> "cape" that I had prepared to mount XBEE on BBB. The Rx/Tx pins >> were >>> swapped due to oversight. Everything works fine now. >> It had to be something like that! :-) >> -- >> Chris Green >> ยท > > -- > Chris Green -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
