After you flash the eMMC, make sure you remove the uSD card. Otherwise it will try and flash it again and if you stop that process, will not boot. Also make sure you power cycle the board after the reflashing process.
Gerald On Sun, Feb 23, 2014 at 10:19 AM, Pariyan Shah <[email protected]>wrote: > All of a sudden my BBB would not boot up. So I decided to flash the eMMC > image. Followed steps from - > http://www.elinux.org/Beagleboard:Updating_The_Software > > I had no issues following them step by step and got all USRs brighten at > the end of process (yes, took around 45~55 min) > But the BBB doesnt boot after flashing. Please help me out, I am not able > to figureout the problem. > > > > > P.S.- I then downloaded another the image for booting directly from > microSD. This process worked for me, but I am not able to connect to > internet. I feel there are problems because I am using microSD for booting > it. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
