hello I am trying to use the gpio of bbxm.
I follow the step of this link: http://elinux.org/BeagleBoardUbuntu#BeagleBoard_xM using the prebuilt image. I can boot the board successfully. However, I encounter a problem that even i try to set the gpio pin 139 to "low" it still output 1.8V. But I can successfully control it with Angsrom system.(With the same command.) Is there any one can help me?Thanks! -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
