I answered my own question when I remembered an old post by Marcin on a similar issue. The answer there was to clear the bvfs cache with "clear_bvfs_cache yes" in bconsole. This had the desired effect.
-Chris- On Fri, 26 May 2023, 20:45 Chris Wilkinson, <winstonia...@gmail.com> wrote: > When I use the restore wizard and get to step 3 where the file selection > boxes are, I get an empty path box at the top and empty boxes below with > this message. > > "No file found for selected backup. It can mean file records for this > backup are pruned. Restoring selected files is not available but if you > continue, there will be performed full restore all backup files. > Path: <empty> > > In the past I have typed / in the path box and the selection box then > populates. Today this isn't working, the selection box remains empty except > for .0 and ..0 > > The file records haven't been pruned since the backup job had just run > successfully. If I run the same restore manually, it runs OK and I can > follow its progress in Baculum as usual. > > The one job that the wizard works for is the catalog. This is stored > locally whereas for all the non-working restores, volumes are stored on > mounted USB disks or CIFS shares > > I wondered if this might be Bacula not seeing the volumes. Ls on the > storage device shows all volumes are owned by bacula:tape, 0x640 and the SD > runs as bacula:tape so it doesn't seem to be a permissions issue. Backups > are working normally. > > I turned on debug and ran a restore again but am not seeing anything out > of the ordinary in the log file. Its 300k so won't post it here. > > I'm somewhat stuck now what to check next. Any suggestions would be most > welcome. > > Thanks > > -Chris- >
_______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
