On 20/01/2023 04:30, Lee Damon wrote:
We recently replaced a working LTO5 + Scalar i40 jukebox with an IBM
LTO8 tape + Scalar i3 jukebox. The controller and all software remained
the same. I am suspecting a configuration problem and would greatly
appreciate guidance.
When I tried to label the new tapes it loaded the first one fine, labled
it fine, then failed miserably to unload it. I tried adding the "Offline
On Unmount" command to the config (see below) but that didn't help.
I then tried running
/usr/bin/sudo /sbin/btape -c /etc/bacula/bacula-sd.conf /dev/tape/0
which worked fine until it got to the 'test the autochanger' part of the
test,
then failed just as miserably. The results are different (I/O errors) if
the unmount
setting is there, but it fails either way.
I'll attach two script files that show various btape runs. Note that between
the tests I did the following reset:
sudo mt -f /dev/tape/0 rewoffl
sudo mtx -f /dev/changer/0 unload 1
sudo mtx -f /dev/changer/0 load 1
Nothing interesting shows up in the system logs.
I would turn on debug in mtx-changer.conf - set debug_level=100 - and
see what comes out.
Cheers,
Gary B-)
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
