Hi Ray,
If the drive is SCSI it might be a termination issue. Does the drive
show up in the BIOS POST screen's SCSI section with the other devices?
What's the output of "cat /proc/scsi/scsi"? The only driver you should
need is "st" (SCSI tape) if it's seeing the other attached devices and
the controller itself.
On 2022-08-01 17:32, Clouse, Raymond [JT4 LLC] wrote:
Our original backup solution was an orphaned WD software paired with an Ultrium
4 LTO StorageLoader tape drive. As it was orphaned we got a new Ultrium 7 and,
with the help of this mailing list, got it working with Bacula and now it's our
primary backup solution. Thank you.
But we want to use the old drive as a backup to the backup. We installed RHEL
7 (couldn't do 8 or 9 because the Dell 2950's RAID array is no longer
supported) and the PERC 6i SCSI controller is seen in dmesg and created
/dev/sg0, sg1, and sg2. But it doesn't see the tape drive so sg4 and sg5
aren't created.
Do I need a driver for this? Is RHEL 7 able to see the drive?
--
Ray Clouse
System Administrator V, MCS Development
raymond.clo...@jt4llc.com
raymond.clouse....@us.af.mil
661-277-6464 (office)
714-699-3176 (cell)
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
