I have an lt04 tape system. All jobs write to the tapes in one pool. A specific tapw was in the drive, half full or so from oler backup jobs
During a tape job today, we had a power fail due to flickering power. Nothing went off completely, but tape stopped writing and bacula timed out and marked job cancelled and marked tape status 'error' So I reset all, system runs fine on other tapes. So I mark tape in error back to append Trying to use it, bacula seeks to end of old data, hits eot and dies with i/o error Is there and way to start using the tape again? The command 'list volumes' shows how much tape is actually used. I think i need to write eofs at the end of the old data. How do i seek to end of old data and weof at end. Or should i just mark tape full to save the old savesets on it? +---------------------------------------------------------------------- |This was sent by p...@isone.biz via Backup Central. |Forward SPAM to ab...@backupcentral.com. +---------------------------------------------------------------------- ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
