Thanks @Jeremy and @Andre Turns out I had to set the "SDAddress" property in the bacula-sd config elf-definition to the actual address of the server. If left undefined it binds to the first available IP address, which is presumably localhost. Also needs the actual address to be specified for the SLR7 tape device in the bacula-dir config "Storage" section.
An unrelated question, but one which naturally occurs now...as the laptop will obviously be disconnected at some times, how can I stop the job running if the remote client isn't connected? Otherwise the job will sit there indefinitely and block anything afterwards. Ideally I want it to wait a pre-defined timeout (e.g. 2 mins) and then give up until next scheduled time. Thanks again, Andrew +---------------------------------------------------------------------- |This was sent by and...@wasielewski.co.uk via Backup Central. |Forward SPAM to ab...@backupcentral.com. +---------------------------------------------------------------------- ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
