>> Hi folks, >> >> I am trying to setup a new IBM TS3200 library running on CentOS 5.5 64 >> bit. The Bacula version is 5.0.2 and the tape drives are LTO4s. I have >> successfully setup a couple of other exact type libraries in the past >> and had no issues albeit running older Bacula 2.4.X version. I went >> through exact same steps I have kept as my documentation and it is >> stumping me at the last stage where I cannot label the new tapes. I >> noticed in the older version mtx-changer did not read mtx-changer.conf >> file. I tried to compare the two and adjusted as necessary but still >> no go. Any ideas? TIA. >> >> ## Error message from bconsole: >> *label barcodes Storage=TS3200_1_DRV1 Pool=Scratch Slots=1 >> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ... >> 3306 Issuing autochanger "slots" command. >> Device "LTO4_1" has 47 slots. >> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ... >> 3306 Issuing autochanger "list" command. >> The following Volumes will be labeled: >> Slot Volume >> ============== >> 1 000001 >> Do you want to label these Volumes? (yes|no): yes >> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ... >> Sending label command for Volume "000001" Slot 1 ... >> 3301 Issuing autochanger "loaded? drive 0" command. >> 3302 Autochanger "loaded? drive 0", result: nothing loaded. >> 3304 Issuing autochanger "load slot 1, drive 0" command. >> 3992 Bad autochanger "load slot 1, drive 0": ERR=Child died from >> signal 15: Termination. >> Results=Program killed by Bacula (timeout) >> >> Label command failed for Volume 000001. >> >> >> ## mtx.log shows: >> 20100806-14:14:30 Parms: /dev/sg22 loaded 1 /dev/nst0 0 >> 20100806-14:14:30 Doing mtx -f /dev/sg22 0 -- to find what is loaded >> 20100806-14:14:30 Parms: /dev/sg22 load 1 /dev/nst0 0 >> 20100806-14:14:30 Doing mtx -f /dev/sg22 load 1 0 >> 20100806-14:15:16 The return value for load is 0 >> 20100806-14:15:16 Device /dev/nst0 - not ready, retrying... >> 20100806-14:15:17 Device /dev/nst0 - not ready, retrying... >> 20100806-14:15:18 Device /dev/nst0 - not ready, retrying... > > mtx-changer is a starting point. Sometimes it requires customization. > > See http://www.freebsddiary.org/tape-library.php for how I customized my > copy. > > -- > Dan Langille - http://langille.org/
Turms out the fiber zones were assigned improperly. What I see as /dev/st0 actually was drive 2 on the tape library and vice versa. Remapping the drives in bacula-sd.conf fixed the issue. Thank you all for your input. Win ------------------------------------------------------------------------------ This SF.net email is sponsored by Make an app they can't live without Enter the BlackBerry Developer Challenge http://p.sf.net/sfu/RIM-dev2dev _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
