Thanks to everyone for helping me get the changer recognized. The last
changer I used with Bacula was a 15 slot AIT4 Sony unit. This ML6020 is a
beast in comparison. I ran the btape test as described in the manual:
/usr/local/bacula/sbin/btape -c /usr/local/bacula/etc/bacula-sd.conf/dev/st0
All of the tests on /dev/st0 passed and then I get this:
Ah, I see you have an autochanger configured.
To test the autochanger you must have a blank tape
that I can write on in Slot 1.
Do you wish to continue with the Autochanger test? (y/n): y
So I go on to the changer test and I get this:
=== Autochanger test ===
3301 Issuing autochanger "loaded" command.
Nothing loaded in the drive. OK.
3303 Issuing autochanger "load 1 0" command.
3993 Bad autochanger command: /usr/local/bacula/etc/mtx-changer /dev/sg4
load 1 /dev/st0 0
3993 result="Loading media from Storage Element 1 into drive 0...Source
Element Address 4096 is Empty
": ERR=Child exited with code 1
You must correct this error or the Autochanger will not work.
Now I loaded 20 tapes into this unit. There are 122 slots available for
backups (there other 8 are the import/export slots).. I know the slot
location information on the Dell ML6020 uses an x,y,z schema to determine
location. How do you identify the slot numbers on this changer using
mtx/mtx-changer? Anyone here have experience with the ML60xx series of
changers?
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
