Hello,
Today i tried to add a new tape to the pool:
*label barcodes slots=2
Automatically selected Storage: Autochanger
Connecting to Storage daemon Autochanger at backup:9103 ...
3306 Issuing autochanger "slots" command.
Device "Drive-1" has 16 slots.
Connecting to Storage daemon Autochanger at backup:9103 ...
3306 Issuing autochanger "list" command.
The following Volumes will be labeled:
Slot Volume
==============
2 000010L3
Do you want to continue? (yes|no): yes
Defined Pools:
1: DefaultPool
2: WeeklyPool
3: Scratch
Select the Pool (1-3): 3
Connecting to Storage daemon Autochanger at backup:9103 ...
Sending label command for Volume "000010L3" Slot 2 ...
3301 Issuing autochanger "loaded? drive 0" command.
3302 Autochanger "loaded? drive 0", result: nothing loaded.
3304 Issuing autochanger "load slot 2, drive 0" command.
3305 Autochanger "load slot 2, drive 0", status is OK.
3301 Issuing autochanger "loaded? drive 0" command.
3302 Autochanger "loaded? drive 0", result is Slot 2.
block.c:993 Read error on fd=4 at file:blk 0:0 on device "Drive-1"
(/dev/nst0). ERR=Input/output error.
3000 OK label. VolBytes=64512 DVD=0 Volume="000010L3" Device="Drive-1"
(/dev/nst0)
Catalog record for Volume "000010L3", Slot 2 successfully created.
There is a "read error" message. Should I ignore this message or not ?
The tape was never used before.
Any ideas ?
Regards,
Robert Garwacki
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
