Hi All,
I have this problem where I've got a mix of 20/40GB and 40/80GB DLT
tapes that are in 1 pool configured to backup using 1 tape drive. The
problem is, all of them seem to be acting like 20/40GB tapes including
the higher capacity ones. I've not been able to get the 40/80GB tape to
store even remotely near 40GB let alone the compressed capacity of 80GB.
I was wondering whether anyone had similar problems before...
The funny thing is, I've got a another pool that uses another tape drive
that all backup correctly. Most backup are close to around 68-72GB,
which I believe is fine. I've configured both pools & devices similarly
but don't know why 1 only backs up to around 34GB (acting like a 20/40).
Both tape drives were bough at the same time and are identical models.
Is the mix of tapes causing the problem?
They are currently listed as /dev/nst0 and /dev/nst1 respectively. Is
there any configuration files in outside of bacula-dir that I need to
configure or perhaps in Linux system files perhaps, although I don't
recall any configuration files other than the bacula conf files where
done back during the initial setup.
Thanks!
Kind Regards,
Anwar
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
