Hello,
I had the following problem. After a tape error occured on one old tape,
I wanted to copy the tape contens to disk and from there to a new tape
using the same label than the damaged tape. Therefore I labeled the new
tape with btape.
Copying was successfull, but after all, using readlabel (from btape)
reported that the new tape is in "Default" pool and not like the old
tape in my pool "Inc-Pool".
And here comes my question. Is it possible to set the PoolName while
labeling with btape? Or else is it possible to change the PoolName (on
the Volume Label) after labeling (and maybe copying)?
Thanks for your help.
Tobias
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
