Hello Eric, I ran a small test of Tokyo Cabinet DBM compared to our htable routines.
Inputting 5 million records to htable and then reading them all back takes 7.7 seconds, and uses up 240MB . Inputting 5 million records to TCDBM (using the same records as above) and reading them back takes 1 minute 33 seconds. Using 1 million records, it runs in 8.8 seconds. So, it is a bit slower for at a million records, and quite a bit at 5 million, but that can probably be tuned. In those tests, I did tune it to use something like 40MB of memory. In addition, it mallocs and frees each record returned. He has calls to allow the records to be returned in our own buffers, so this would probably reduce the time a lot. Best regards, Kern ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Bacula-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bacula-devel
