I've been working on a project, all was going as expected, then
everything started behaving strange. I'll spare the history and get to
the details.
I can write a simple application but it will not run - power cycling it
or doing whatever I can to it. I've got status leds attached to F0, F1,
and F2 and F1 and F2 are held high. If i use the JTAG bebugger and
ender debug mode, it works fine. If I unplug it after entering debug
mode, it works fine. If I power cycle it after that point, it works
fine. It seems that it's getting stuck at some point and that the
debugger gets it unstuck.
This happened on an ATMEGA64. I swapped it out with an ATMEGA128 with
the same results. All the fuses look fine -- otherwise, I have no idea
what's causing this. The thing is that it worked fine for the longest
time, then this started up. Any thoughts? Is it possessed?
thanks,
Reza
_______________________________________________
AVR-GCC-list mailing list
AVR-GCC-list@nongnu.org
http://lists.nongnu.org/mailman/listinfo/avr-gcc-list
