On 2020-11-12 20:49, Arend Van Spriel wrote:
On 11/12/2020 11:55 AM, Wen Gong wrote:
On 2017-03-08 21:20, Johannes Berg wrote:
From: Johannes Berg <[email protected]>
[...]
@@ -2685,6 +2686,21 @@ static int ieee80211_set_bitrate_mask(struct
wiphy *wiphy,
return ret;
}
+ /*
+ * If active validate the setting and reject it if it doesn't
leave
+ * at least one basic rate usable, since we really have to be
able
+ * to send something, and if we're an AP we have to be able to
do
+ * so at a basic rate so that all clients can receive it.
+ */
+ if (rcu_access_pointer(sdata->vif.chanctx_conf) &&
+ sdata->vif.bss_conf.chandef.chan) {
+ u32 basic_rates = sdata->vif.bss_conf.basic_rates;
+ enum nl80211_band band =
sdata->vif.bss_conf.chandef.chan->band;
+
+ if (!(mask->control[band].legacy & basic_rates))
+ return -EINVAL;
If user want to use “iw wlan0 set bitrates legacy-5 54” to set it to
fixed in 54M and 54M is
not basic rate in AP's becaon as example of below, then the iw command
will fail.
Which was the intent of this change, wasn't it? You want to allow
anyway or you want a clear error message as to why it fails?
We need to set the tx rate to fixed at a single rate, e.g.,
54M/48M/36M... for a test case.
I do not want a clear error message, I want to the 54M rate pass/set
success to lower wlan driver.
Then lower wlan driver can handle it.
Regards,
Arend
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
