From: Alagu Sankar <alagusan...@silex-india.com>
HTT High Latency (ATH10K_DEV_TYPE_HL) does not use txdone_fifo at all, we don't
even initialise it by skipping ath10k_htt_tx_alloc_buf() in
ath10k_htt_tx_start(). Because of this using QCA6174 SDIO
ath10k_htt_rx_tx_compl_ind() will crash when it accesses unitialised
txdone_fifo. So skip txdone_fifo when using High Latency mode.
Tested with QCA6174 SDIO with firmware WLAN.RMH.4.4.1-00007-QCARMSWP-1.
Co-developed-by: Wen Gong <wg...@codeaurora.org>
Signed-off-by: Alagu Sankar <alagusan...@silex-india.com>
Signed-off-by: Wen Gong <wg...@codeaurora.org>
Signed-off-by: Kalle Valo <kv...@codeaurora.org>
---
drivers/net/wireless/ath/ath10k/htt_rx.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath10k/htt_rx.c
b/drivers/net/wireless/ath/ath10k/htt_rx.c
index a20ea270d519..8d13d0c3e85e 100644
--- a/drivers/net/wireless/ath/ath10k/htt_rx.c
+++ b/drivers/net/wireless/ath/ath10k/htt_rx.c
@@ -2277,7 +2277,9 @@ static void ath10k_htt_rx_tx_compl_ind(struct ath10k *ar,
* Note that with only one concurrent reader and one concurrent
* writer, you don't need extra locking to use these macro.
*/
- if (!kfifo_put(&htt->txdone_fifo, tx_done)) {
+ if (ar->bus_param.dev_type == ATH10K_DEV_TYPE_HL) {
+ ath10k_txrx_tx_unref(htt, &tx_done);
+ } else if (!kfifo_put(&htt->txdone_fifo, tx_done)) {
ath10k_warn(ar, "txdone fifo overrun, msdu_id %d status
%d\n",
tx_done.msdu_id, tx_done.status);
ath10k_txrx_tx_unref(htt, &tx_done);
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
