Hi,
When we are trying to bring up AP to add mesh interfaces on T1024 board with
kernel-3.12; ath10k drivers backported from 4.4;hostapd 2.5 for 11AC support is
used, then we are getting below error -
----------------------------------------------------------------------------------
T1024# ifconfig mesh0
mesh0 Link encap:Ethernet HWaddr 04:f0:21:1b:7d:b6
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
T1024# ifconfig mesh0 0.0.0.0 up
[ 8694.385554] ath10k_pci 0001:03:00.0: must load driver with rawmode=1 to add
mesh
interfaces
----------------------------------------------------------------------------------
How to resolve this issue, can you please help on this.
Regards,
Sridhar Kondabathini,
Research engineer,
PSG lab,
Center for Development Of Telematics
9480484821.
Disclaimer:
----------
This email and any files transmitted with it are confidential and intended
solely
for
the use of the individual or entity to whom they are addressed. If you are not
the
intended recipient you are notified that disclosing, copying, distributing or
taking
any
action in reliance on the contents of this information is strictly prohibited.
The
sender does not a
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
