>when a worker is stuck in "idle or damping,"
There must be an active connection in worker.
Thomas
Von: "James Moe" <ji...@sohnen-moe.com>
An: assp-test@lists.sourceforge.net
Datum: 05.10.2017 21:46
Betreff: Re: [Assp-test] ASSP ramps up CPU usage after a time
On 10/03/2017 11:30 AM, James Moe wrote:
>
>> GUI -> Worker-Status ???...
>>
> Here is a typical result:
> 1 0 s idle or damping
> 2 47 s sleeping
>
So, yes, when a worker is stuck in "idle or damping," it is looping
uselessly consuming CPU time for no apparent reason.
"DoDamping" is set to 0 (zero).
What would cause a worker to get stuck in a loop?
--
James Moe
moe dot james at sohnen-moe dot com
520.743.3936
Think.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Assp-test mailing list
Assp-test@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/assp-test
DISCLAIMER:
*******************************************************
This email and any files transmitted with it may be confidential, legally
privileged and protected in law and are intended solely for the use of the
individual to whom it is addressed.
This email was multiple times scanned for viruses. There should be no
known virus in this email!
*******************************************************
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Assp-test mailing list
Assp-test@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/assp-test
