> From: Jan de Kruyf <jan.de.kr...@gmail.com> > Date: Tue, 1 Nov 2022 20:48:07 +0100 > > > Hope that helps, > > No, let me show you what happens after the u-boot on mmc0 (just blank > otherwise) > ------- > Hit any key to stop autoboot: 0 > switch to partitions #0, OK > mmc0 is current device > Scanning mmc 0:1... > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > Scanning disk m...@1c0f000.blk... > Found 2 disks > No EFI system partition > BootOrder not defined > EFI boot manager: Cannot load any image > MMC Device 1 not found > no mmc device at slot 1 > scanning bus for devices... > Target spinup took 0 ms. > AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode > flags: ncq stag pm led clo only pmp pio slum part ccc apst > Device 0: (0:0) Vendor: ATA Prod.: WDC WDS500G1R0A Rev: 4110 > Type: Hard Disk > Capacity: 476940.0 MB = 465.7 GB (976773168 x 512) > > Device 0: (0:0) Vendor: ATA Prod.: WDC WDS500G1R0A Rev: 4110 > Type: Hard Disk > Capacity: 476940.0 MB = 465.7 GB (976773168 x 512) > ... is now current device > Scanning scsi 0:1... > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > BootOrder not defined > EFI boot manager: Cannot load any image > Found EFI removable media binary efi/boot/bootarm.efi > 117796 bytes read in 9 ms (12.5 MiB/s) > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > Booting /efi\boot\bootarm.efi > disks: sd0 > >> OpenBSD/armv7 BOOTARM 1.19 > open(tftp0a:/etc/boot.conf): Operation not permitted > boot> > booting tftp0a:/bsd: open tftp0a:/bsd: Operation not permitted > failed(1). will try /bsd > boot>
Ah, that is a clear sign of a broken U-Boot. You may have better > The open-BSD supplied u-boot has a problem with the ethernet: it does not > work. And presumably the ram clockspeed might be too high. It was lowered > considerably at one stage by olimex. Did you try using the OpenBSD U-Boot together with the Olimex DTB file? > Hopefully you have some more light. > Where is the source for the openBSD supied u-boot? It is U-Boot 2021.10 with a limited set of patches applied. You can find the patches in the ports tree: https://github.com/openbsd/ports/tree/master/sysutils/u-boot/patches But it doesn't look like any of them will affect this board.
