On 10/15/21 11:15, Jonathan Gray wrote:
On Fri, Oct 15, 2021 at 10:56:06AM +0000, minus wrote:
On 10/15/21 01:39, Brandon Mercer wrote:
On Thu, Oct 14, 2021, at 2:44 PM, minus wrote:
Hello arm,
I tried the unattended upgrade on a raspberry pi 4 and the device is not
booting anymore. I took another usb drive and copied miniroot70, and the
same behaviour is occurring. I tried to copy miniroot69 and it is
working correctly. Is anyone having the same problem?
Below are the logs grabbed from the serial console, particularly 70
is stalling for more than one minute on
Yes, I've run into the same thing. I believe there is something mention
on bugs@ about this. For me, copying in u-boot 2021.01 allows
everything > to work correctly. I wish everything was easier around the boot
blocks of arm.
Brandon
Hello Brandon, copying that version of u-boot fixed it for me too.
Thank you!
Snapshots have U-Boot 2021.10 if that doesn't help someone with hardware
will have to bisect. This isn't a problem that appears with rpi3.
For me snapshot hangs at bcmpcie for a while and later on panics:
U-Boot 2021.10 (Oct 06 2021 - 23:34:03 -0600)
DRAM: 3.9 GiB
RPI 4 Model B (0xc03112)
MMC: mmcnr@7e300000: 1, emmc2@7e340000: 0
Loading Environment from FAT... Card did not respond to voltage select!
: -110
In: serial
Out: serial
Err: serial
Net: eth0: ethernet@7d580000
PCIe BRCM: link up, 5.0 Gbps x1 (SSC)
starting USB...
Bus xhci_pci: Register 5000420 NbrPorts 5
Starting the controller
USB XHCI 1.00
scanning bus xhci_pci for devices... 3 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found
Hit any key to stop autoboot: 0
Card did not respond to voltage select! : -110
Card did not respond to voltage select! : -110
Device 0: Vendor: Sony Rev: PMAP Prod: Storage Media
Type: Removable Hard Disk
Capacity: 7425.5 MB = 7.2 GB (15207552 x 512)
... is now current device
Scanning usb 0:1...
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
Card did not respond to voltage select! : -110
Scanning disk mm...@7e300000.blk...
Disk mm...@7e300000.blk not ready
Card did not respond to voltage select! : -110
Scanning disk em...@7e340000.blk...
Disk em...@7e340000.blk not ready
Scanning disk usb_mass_storage.lun0...
Found 3 disks
No EFI system partition
BootOrder not defined
EFI boot manager: Cannot load any image
Found EFI removable media binary efi/boot/bootaa64.efi
170694 bytes read in 10 ms (16.3 MiB/s)
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
Booting /efi\boot\bootaa64.efi
disks: sd0*
>> OpenBSD/arm64 BOOTAA64 1.6
boot>
cannot open sd0a:/etc/random.seed: No such file or directory
booting sd0a:/bsd: 2572592+698580+13009456+629824
[215607+109+596064+232844]=0x14012c8
type 0x0 pa 0x0 va 0x0 pages 0x1 attr 0x8
type 0x7 pa 0x1000 va 0x1000 pages 0x1ff attr 0x8
type 0x2 pa 0x200000 va 0x200000 pages 0x4000 attr 0x8
type 0x7 pa 0x4200000 va 0x4200000 pages 0x3cf0 attr 0x8
type 0x9 pa 0x7ef0000 va 0x7ef0000 pages 0x20 attr 0x8
type 0x7 pa 0x7f10000 va 0x7f10000 pages 0x31bf0 attr 0x8
type 0x4 pa 0x39b00000 va 0x39b00000 pages 0x1 attr 0x8
type 0x7 pa 0x39b01000 va 0x39b01000 pages 0x1 attr 0x8
type 0x2 pa 0x39b02000 va 0x39b02000 pages 0x100 attr 0x8
type 0x1 pa 0x39c02000 va 0x39c02000 pages 0x2a attr 0x8
type 0x4 pa 0x39c2c000 va 0x39c2c000 pages 0x8 attr 0x8
type 0x6 pa 0x39c34000 va 0x26a06a0000 pages 0x1 attr 0x8000000000000008
type 0x4 pa 0x39c35000 va 0x39c35000 pages 0x3 attr 0x8
type 0x6 pa 0x39c38000 va 0x26a06a4000 pages 0x3 attr 0x8000000000000008
type 0x4 pa 0x39c3b000 va 0x39c3b000 pages 0x1 attr 0x8
type 0x6 pa 0x39c3c000 va 0x26a06a8000 pages 0x4 attr 0x8000000000000008
type 0x4 pa 0x39c40000 va 0x39c40000 pages 0x8 attr 0x8
type 0x2 pa 0x39c48000 va 0x39c48000 pages 0x1408 attr 0x8
type 0x5 pa 0x3b050000 va 0x26a1abc000 pages 0x10 attr 0x8000000000000008
type 0x2 pa 0x3b060000 va 0x3b060000 pages 0xa0 attr 0x8
type 0x4 pa 0x3b100000 va 0x3b100000 pages 0x200 attr 0x8
type 0x0 pa 0x3ee5c000 va 0x3ee5c000 pages 0x1 attr 0x8
type 0x4 pa 0x40000000 va 0x40000000 pages 0xbc000 attr 0x8
type 0xb pa 0xfe100000 va 0x26a1acc000 pages 0x1 attr 0x8000000000000000
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2021 OpenBSD. All rights reserved.
https://www.OpenBSD.org
OpenBSD 7.0-current (RAMDISK) #1270: Fri Oct 15 05:32:46 MDT 2021
dera...@arm64.openbsd.org:/usr/src/sys/arch/arm64/compile/RAMDISK
real mem = 4123914240 (3932MB)
avail mem = 3960262656 (3776MB)
random: good seed from bootblocks
mainbus0 at root: Raspberry Pi 4 Model B Rev 1.2
cpu0 at mainbus0 mpidr 0: ARM Cortex-A72 r0p3
cpu0: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu0: 1024KB 64b/line 16-way L2 cache
cpu0: CRC32,ASID16
efi0 at mainbus0: UEFI 2.8
efi0: Das U-Boot rev 0x20211000
"system" at mainbus0 not configured
"axi" at mainbus0 not configured
simplebus0 at mainbus0: "soc"
bcmclock0 at simplebus0
bcmmbox0 at simplebus0
bcmgpio0 at simplebus0
bcmaux0 at simplebus0
ampintc0 at simplebus0 nirq 256, ncpu 4: "interrupt-controller"
syscon0 at simplebus0: "avs-monitor"
"thermal" at syscon0 not configured
bcmdmac0 at simplebus0: DMA0 DMA2 DMA4 DMA5 DMA6 DMA7 DMA8 DMA9
"timer" at simplebus0 not configured
pluart0 at simplebus0: console
"local_intc" at simplebus0 not configured
bcmdog0 at simplebus0
bcmirng0 at simplebus0
"firmware" at simplebus0 not configured
"power" at simplebus0 not configured
"mailbox" at simplebus0 not configured
sdhc0 at simplebus0
sdhc0: SDHC 3.0, 250 MHz base clock
sdmmc0 at sdhc0: 4-bit, sd high-speed, mmc high-speed
"gpiomem" at simplebus0 not configured
"fb" at simplebus0 not configured
"vcsm" at simplebus0 not configured
"clocks" at mainbus0 not configured
"phy" at mainbus0 not configured
"clk-27M" at mainbus0 not configured
"clk-108M" at mainbus0 not configured
simplebus1 at mainbus0: "emmc2bus"
sdhc1 at simplebus1
sdhc1: SDHC 3.0, 100 MHz base clock
sdmmc1 at sdhc1: 8-bit, sd high-speed, mmc high-speed, ddr52, dma
"arm-pmu" at mainbus0 not configured
agtimer0 at mainbus0: 54000 kHz
simplebus2 at mainbus0: "scb"
bcmpcie0 at simplebus2
pci0 at bcmpcie0
bse0 at simplebus2: address dc:a6:32:84:c5:6a
brgphy0 at bse0 phy 1: BCM54210E 10/100/1000baseT PHY, rev. 2
"dma" at simplebus2 not configured
"hevc-decoder" at simplebus2 not configured
"rpivid-local-intc" at simplebus2 not configured
"h264-decoder" at simplebus2 not configured
"vp9-decoder" at simplebus2 not configured
"leds" at mainbus0 not configured
"sd_io_1v8_reg" at mainbus0 not configured
"sd_vcc_reg" at mainbus0 not configured
"fixedregulator_3v3" at mainbus0 not configured
"fixedregulator_5v0" at mainbus0 not configured
simplebus3 at mainbus0: "v3dbus"
"bootloader" at mainbus0 not configured
sdmmc1: can't enable card
bwfm0 at sdmmc0 function 1
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 2 not configured
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 3 not configured
softraid0 at root
scsibus0 at softraid0: 256 targets
root on rd0a swap on rd0b dump on rd0b
WARNING: CHECK AND RESET THE DATE!
gpio at bcmgpio0 not configured
bwfm0: failed loadfirmware of file
brcmfmac43455-sdio.raspberrypi,4-model-b.bin
panic: do_el0_error
syncing disks... done
dump to dev 17,1 not possible
rebooting...
