Dear All,
I have now moved from the snapshot to the release version. It is 100x
faster than the snapshot, but still not where I expected.
Probably I still have not understood what I need to do with AHCI and
Devicetree.
I will keep trying but for now, please accept my dmesg and the new
measurement.
Best regards,
Oliver
OpenBSD 6.7 (GENERIC.MP) #602: Thu May 7 13:45:48 MDT 2020
dera...@arm64.openbsd.org:/usr/src/sys/arch/arm64/compile/GENERIC.MP
real mem = 2002501632 (1909MB)
avail mem = 1910878208 (1822MB)
mainbus0 at root: Raspberry Pi 4 Model B Rev 1.1
cpu0 at mainbus0 mpidr 0: ARM Cortex-A72 r0p3
cpu0: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu0: 1024KB 64b/line 16-way L2 cache
efi0 at mainbus0: UEFI 2.7
efi0: https://github.com/pftf/RPi4 rev 0x10000
smbios0 at efi0: SMBIOS 3.3.0
smbios0: vendor https://github.com/pftf/RPi4 version "UEFI Firmware v1.13" date
May 13 2020 10:40:33
smbios0: Sony UK Raspberry Pi 4 Model B
apm0 at mainbus0
psci0 at mainbus0: PSCI 1.1, SMCCC 1.2
"system" at mainbus0 not configured
"axi" at mainbus0 not configured
simplebus0 at mainbus0: "soc"
bcmclock0 at simplebus0
bcmmbox0 at simplebus0
bcmgpio0 at simplebus0
bcmaux0 at simplebus0
ampintc0 at simplebus0 nirq 256, ncpu 4 ipi: 0, 1: "interrupt-controller"
bcmdmac0 at simplebus0: DMA0 DMA2 DMA4 DMA5 DMA6 DMA7
"timer" at simplebus0 not configured
bcmirng0 at simplebus0
pluart0 at simplebus0: console
com0 at simplebus0: ns16550, no working fifo
"local_intc" at simplebus0 not configured
bcmdog0 at simplebus0
"clock" at simplebus0 not configured
simplebus1 at simplebus0: "firmware"
"gpio" at simplebus1 not configured
"power" at simplebus0 not configured
sdhc0 at simplebus0
sdhc0: SDHC 3.0, 250 MHz base clock
sdmmc0 at sdhc0: 4-bit, sd high-speed, mmc high-speed
"gpiomem" at simplebus0 not configured
"fb" at simplebus0 not configured
"vcsm" at simplebus0 not configured
"thermal" at simplebus0 not configured
"clocks" at mainbus0 not configured
"phy" at mainbus0 not configured
"clk-108M" at mainbus0 not configured
"firmware-clocks" at mainbus0 not configured
"arm-pmu" at mainbus0 not configured
agtimer0 at mainbus0: tick rate 54000 KHz
simplebus2 at mainbus0: "scb"
bcmpcie0 at simplebus2
pci0 at bcmpcie0
ppb0 at pci0 dev 0 function 0 "Broadcom BCM2711" rev 0x10
pci1 at ppb0 bus 1
xhci0 at pci1 dev 0 function 0 "VIA VL805 xHCI" rev 0x01: intx, xHCI 1.0
usb0 at xhci0: USB revision 3.0
uhub0 at usb0 configuration 1 interface 0 "VIA xHCI root hub" rev 3.00/1.00
addr 1
bse0 at simplebus2: address dc:a6:32:32:5d:7b
brgphy0 at bse0 phy 1: BCM54210E 10/100/1000baseT PHY, rev. 2
"dma" at simplebus2 not configured
"mailbox" at simplebus2 not configured
"hevc-decoder" at simplebus2 not configured
"rpivid-local-intc" at simplebus2 not configured
"h264-decoder" at simplebus2 not configured
"vp9-decoder" at simplebus2 not configured
"leds" at mainbus0 not configured
"sd_io_1v8_reg" at mainbus0 not configured
"fixedregulator_3v3" at mainbus0 not configured
"fixedregulator_5v0" at mainbus0 not configured
simplebus3 at mainbus0: "v3dbus"
simplebus4 at mainbus0: "emmc2bus"
sdhc1 at simplebus4
sdhc1: SDHC 3.0, 100 MHz base clock
sdmmc1 at sdhc1: 8-bit, sd high-speed, mmc high-speed, dma
"sd_vcc_reg" at mainbus0 not configured
cpu1 at mainbus0 mpidr 1: ARM Cortex-A72 r0p3
cpu1: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu1: 1024KB 64b/line 16-way L2 cache
cpu2 at mainbus0 mpidr 2: ARM Cortex-A72 r0p3
cpu2: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu2: 1024KB 64b/line 16-way L2 cache
cpu3 at mainbus0 mpidr 3: ARM Cortex-A72 r0p3
cpu3: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu3: 1024KB 64b/line 16-way L2 cache
scsibus0 at sdmmc1: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <SD/MMC, SU04G, 0080> removable
sd0: 3781MB, 512 bytes/sector, 7744512 sectors
uhub1 at uhub0 port 1 configuration 1 interface 0 "VIA Labs USB2.0 Hub" rev
2.10/4.21 addr 2
bwfm0 at sdmmc0 function 1
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 2 not configured
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 3 not configured
umass0 at uhub1 port 1 configuration 1 interface 0 "General USB Flash Disk" rev
2.00/11.00 addr 3
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets, initiator 0
sd1 at scsibus1 targ 1 lun 0: <General, USB Flash Disk, 1100> removable
serial.090c1000KL0000000586
sd1: 3837MB, 512 bytes/sector, 7858176 sectors
vscsi0 at root
scsibus2 at vscsi0: 256 targets
softraid0 at root
scsibus3 at softraid0: 256 targets
bootfile: sd0a:/bsd
boot device: sd0
root on sd1a (2d1f2fa8d77f40fe.a) swap on sd1b dump on sd1b
WARNING: / was not properly unmounted
gpio0 at bcmgpio0: 58 pins
bwfm0: address dc:a6:32:32:5d:7c
s10000@hexa:/pool/os10000$ ping 192.168.180.1
PING 192.168.180.1 (192.168.180.1) 56(84) bytes of data.
64 bytes from 192.168.180.1: icmp_seq=1 ttl=255 time=212 ms
64 bytes from 192.168.180.1: icmp_seq=2 ttl=255 time=16.3 ms
64 bytes from 192.168.180.1: icmp_seq=3 ttl=255 time=21.4 ms
64 bytes from 192.168.180.1: icmp_seq=4 ttl=255 time=60.2 ms
64 bytes from 192.168.180.1: icmp_seq=5 ttl=255 time=32.0 ms
64 bytes from 192.168.180.1: icmp_seq=6 ttl=255 time=37.5 ms
64 bytes from 192.168.180.1: icmp_seq=7 ttl=255 time=8.89 ms
64 bytes from 192.168.180.1: icmp_seq=8 ttl=255 time=13.4 ms
64 bytes from 192.168.180.1: icmp_seq=9 ttl=255 time=18.5 ms
64 bytes from 192.168.180.1: icmp_seq=10 ttl=255 time=57.0 ms
64 bytes from 192.168.180.1: icmp_seq=11 ttl=255 time=28.9 ms
64 bytes from 192.168.180.1: icmp_seq=12 ttl=255 time=0.901 ms
64 bytes from 192.168.180.1: icmp_seq=13 ttl=255 time=6.43 ms
64 bytes from 192.168.180.1: icmp_seq=14 ttl=255 time=11.5 ms
64 bytes from 192.168.180.1: icmp_seq=15 ttl=255 time=16.4 ms
64 bytes from 192.168.180.1: icmp_seq=16 ttl=255 time=156 ms
64 bytes from 192.168.180.1: icmp_seq=17 ttl=255 time=362 ms
64 bytes from 192.168.180.1: icmp_seq=18 ttl=255 time=33.3 ms
^C
--- 192.168.180.1 ping statistics ---
18 packets transmitted, 18 received, 0% packet loss, time 17023ms
rtt min/avg/max/mdev = 0.901/60.674/361.904/90.327 ms
