On 09/21/17 15:44, Jan Stary wrote:
I just reinstalled a beaglebone black with the latest snapshot.
The upgrade went fine, but after the reboot, the new /bsd keeps
rebooting over and over again. It just says
booting sd0a:/bsd: 3919680+167292+561628 [281802+90+520048+244541]=0x5718f4
then nothing for a few seconds, then it reboots anew.
Is anyone seeign the same?
Jan
doesn't sd0 hold the linux install? On my bbb sd1 hold the OpenBSD
partition and you have to hold one of the buttons on board for first
boot (I'm remote from my bbb atm so cannot remember which button needs
to held down on first boot)
eg:
sd0 at scsibus0 targ 1 lun 0: <SD/MMC, MMC02G, 0000> SCSI2 0/direct
removable
sd0: 1832MB, 512 bytes/sector, 3751936 sectors
scsibus1 at sdmmc0: 2 targets, initiator 0
sd1 at scsibus1 targ 1 lun 0: <SD/MMC, SU08G, 0080> SCSI2 0/direct removable
sd1: 7580MB, 512 bytes/sector, 15523840 sectors
boot device: sd0
root on sd1a (df088aa460d72037.a) swap on sd1b dump on sd1b
my build is a couple of weeks old:
OpenBSD 6.2-beta (GENERIC) #59: Wed Sep 6 03:25:28 MDT 2017
dera...@armv7.openbsd.org:/usr/src/sys/arch/armv7/compile/GENERIC
hth
Fred
