On Thu, Mar 02, 2017 at 02:24:57PM +1100, Jonathan Gray wrote:
> 
> I don't have any allwinner systems here but perhaps a newer u-boot would
> help?

Yes. Thank you.

--

U-Boot SPL 2017.03-rc3 (Mar 02 2017 - 14:13:26)
DRAM: 1024 MiB
CPU: 912000000Hz, AXI/AHB/APB: 3/2/2
Trying to boot from MMC1


U-Boot 2017.03-rc3 (Mar 02 2017 - 14:13:26 -0300) Allwinner Technology

CPU:   Allwinner A20 (SUN7I)
Model: LeMaker Banana Pi
I2C:   ready
DRAM:  1 GiB
MMC:   SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment

Setting up a 720x576i composite-pal console (overscan 32x20)
In:    serial
Out:   vga
Err:   vga
SCSI:  SATA link 0 timeout.
AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part ccc apst
Net:   eth0: ethernet@01c50000
starting USB...
USB0:   USB EHCI 1.00
USB1:   USB OHCI 1.0
USB2:   USB EHCI 1.00
USB3:   USB OHCI 1.0
scanning bus 0 for devices... 1 USB Device(s) found
scanning bus 2 for devices... 1 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
reading /sun7i-a20-bananapi.dtb
35071 bytes read in 30 ms (1.1 MiB/s)
Found EFI removable media binary efi/boot/bootarm.efi
reading efi/boot/bootarm.efi
64684 bytes read in 41 ms (1.5 MiB/s)
## Starting EFI application at 42000000 ...
Scanning disks on scsi...
Scanning disks on usb...
Scanning disks on mmc...
MMC Device 1 not found
MMC Device 2 not found
MMC Device 3 not found
Found 6 disks
>> OpenBSD/armv7 BOOTARM 0.5
boot>
cannot open sd0a:/etc/random.seed: No such file or directory
booting sd0a:/bsd: 2154708+7992748+438536 [80+305136+146379]=0xa88c5c

OpenBSD/armv7 booting ...
arg0 0xc0d88c5c arg1 0x0 arg2 0x48000000
Allocating page tables
freestart = 0x40d89000, free_pages = 258273 (0x0003f0e1)
IRQ stack: p0x40db7000 v0xc0db7000
ABT stack: p0x40db8000 v0xc0db8000
UND stack: p0x40db9000 v0xc0db9000
SVC stack: p0x40dba000 v0xc0dba000
Creating L1 page table at 0x40d8c000
Mapping kernel
Constructing L2 page tables
undefined page pmap board type: 0
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2017 OpenBSD. All rights reserved.  https://www.OpenBSD.org

OpenBSD 6.0-current (RAMDISK) #48: Wed Mar  1 18:48:03 MST 2017
    dera...@armv7.openbsd.org:/usr/src/sys/arch/armv7/compile/RAMDISK
real mem  = 1072078848 (1022MB)
avail mem = 1037017088 (988MB)
mainbus0 at root: LeMaker Banana Pi
cpu0 at mainbus0: ARM Cortex A7 rev 4 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 32KB(32b/l,2way) I-cache, 32KB(64b/l,4way) wr-back D-cache
cortex0 at mainbus0
psci0 at mainbus0
agtimer0 at mainbus0: tick rate 24000 KHz
sxiccmu0 at mainbus0
simplebus0 at mainbus0: "soc"
sxipio0 at simplebus0: 175 pins
sximmc0 at simplebus0
sdmmc0 at sximmc0: 4-bit, sd high-speed, mmc high-speed, dma
ehci0 at simplebus0
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 configuration 1 interface 0 "Allwinner EHCI root hub" rev 
2.00/1.00 addr 1
sxiahci0 at simplebus0: AHCI 1.1
scsibus0 at sxiahci0: 32 targets
ehci1 at simplebus0
usb1 at ehci1: USB revision 2.0
uhub1 at usb1 configuration 1 interface 0 "Allwinner EHCI root hub" rev 
2.00/1.00 addr 1
sxidog0 at simplebus0
sxirtc0 at simplebus0
com0 at simplebus0: ns16550, no working fifo
com0: console
com1 at simplebus0: ns16550, no working fifo
com2 at simplebus0: ns16550, no working fifo
dwge0 at simplebus0
dwge0: Ethernet address: 02:96:0a:01:3c:5e
rgephy0 at dwge0 phy 1: RTL8169S/8110S/8211 PHY, rev. 5
ampintc0 at simplebus0 nirq 160
gpio0 at sxipio0: 32 pins
gpio1 at sxipio0: 32 pins
gpio2 at sxipio0: 32 pins
gpio3 at sxipio0: 32 pins
gpio4 at sxipio0: 32 pins
gpio5 at sxipio0: 32 pins
gpio6 at sxipio0: 32 pins
gpio7 at sxipio0: 32 pins
gpio8 at sxipio0: 32 pins
sximmc0: timeout updating clock
sximmc0: timeout updating clock
sximmc0: timeout updating clock
sximmc0: timeout updating clock
sximmc0: timeout updating clock
sximmc0: timeout updating clock
sdmmc0: can't enable card
sximmc0: timeout updating clock
boot device: lookup 'sd0a:/bsd' failed.
root on rd0a swap on rd0b dump on rd0b
WARNING: clock lost 17227 days
WARNING: CHECK AND RESET THE DATE!
erase ^?, werase ^W, kill ^U, intr ^C, status ^T

Welcome to the OpenBSD/armv7 6.0 installation program.
(I)nstall, (U)pgrade, (A)utoinstall or (S)hell?

--
db

Reply via email to