I tried the latest snapshot again. It works now! I was able to install without a problem. Thank you whoever you are that fixed something!
On Mon, Aug 15, 2016 at 10:07 AM, Farid Joubbi <djfa...@gmail.com> wrote: > I used dd in linux to copy the snapshot to a microSD. > Then booted with that card. > > I then did the exact same procedure with 5.9 release using the same card. > That one boots normally (but is not able to install on the internal memory > of the BBB). > > On Sun, Aug 14, 2016 at 4:07 PM, Jonathan Gray <j...@jsg.id.au> wrote: > >> On Sat, Aug 13, 2016 at 02:57:39PM +0200, Farid Joubbi wrote: >> > Hello, >> > >> > Lately I have not been able to boot the current snapshots at all with my >> > bbb. >> > This is what I get with the snapshot from 12th of August: >> > >> > U-Boot SPL 2016.07 (Aug 05 2016 - 23:28:55) >> > Trying to boot from MMC1 >> > ** First descriptor is NOT a primary desc on 0:1 ** >> > MMC partition switch failed >> > *** Warning - MMC partition switch failed, using default environment >> > >> > ** Partition 1 not valid on device 0 ** >> > spl_register_fat_device: fat register err - -1 >> > spl_load_image_fat: error reading image u-boot.img, err - -1 >> > MMC partition switch failed >> > *** Warning - MMC partition switch failed, using default environment >> > >> > spl: no partition table found >> > SPL: failed to boot from all boot devices >> > ### ERROR ### Please RESET the board ### >> > >> > >> > What is going on? >> >> Did you remove the fat partition created by the installer when >> partitioning? >> >> >
