Hello,

Using u-boot v2016.07-rc1 and armv7_machdep.c patch, bsd is booted.
Thanks!

----
U-Boot SPL 2016.07-rc1 (Jun 10 2016 - 22:01:11)
DRAM: 1024 MiB
CPU: 912000000Hz, AXI/AHB/APB: 3/2/2
Trying to boot from MMC1


U-Boot 2016.07-rc1 (Jun 10 2016 - 22:01:11 +0900) Allwinner Technology

CPU:   Allwinner A20 (SUN7I)
Model: LeMaker Banana Pi
I2C:   ready
DRAM:  1 GiB
MMC:   SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment

Setting up a 720x576i composite-pal console (overscan 32x20)
In:    serial
Out:   vga
Err:   vga
SCSI:  SATA link 0 timeout.
AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part ccc apst
Net:   eth0: ethernet@01c50000
starting USB...
USB0:   USB EHCI 1.00
USB1:   USB OHCI 1.0
USB2:   USB EHCI 1.00
USB3:   USB OHCI 1.0
scanning bus 0 for devices... 1 USB Device(s) found
scanning bus 2 for devices... 1 USB Device(s) found
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
reading /sun7i-a20-bananapi.dtb
30295 bytes read in 34 ms (870.1 KiB/s)
Found EFI removable media binary efi/boot/bootarm.efi
reading efi/boot/bootarm.efi
65556 bytes read in 44 ms (1.4 MiB/s)
## Starting EFI application at 0x42000000 ...
Scanning disks on scsi...
Scanning disks on usb...
Scanning disks on mmc...
MMC Device 1 not found
MMC Device 2 not found
MMC Device 3 not found
Found 6 disks
setjmp:64 target=0x7ef59944
>> OpenBSD/armv7 BOOTARM 0.1
boot>
cannot open sd0a:/etc/random.seed: No such file or directory
booting sd0a:/bsd: 3814052+104952+470236 [64+506192+230469]=0x4e8620

OpenBSD/armv7 booting ...
arg0 0x0 arg1 0x10bb arg2 0x48000000
Allocating page tables
freestart = 0x407e9000, free_pages = 259713 (0x0003f681)
IRQ stack: p0x40817000 v0xc0817000
ABT stack: p0x40818000 v0xc0818000
UND stack: p0x40819000 v0xc0819000
SVC stack: p0x4081a000 v0xc081a000
Creating L1 page table at 0x407ec000
Mapping kernel
Constructing L2 page tables
undefined page pmap [ using 737100 bytes of bsd ELF symbol table ]
board type: 4283
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2016 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 6.0-beta (GENERIC) #0: Fri Jun 10 23:31:36 JST 2016
    r...@openbsd-vm.my.domain:/usr/src/sys/arch/armv7/compile/GENERIC
real mem  = 1072078848 (1022MB)
avail mem = 1042829312 (994MB)
warning: no entropy supplied by boot loader
mainbus0 at root: LeMaker Banana Pi
cpu0 at mainbus0: ARM Cortex A7 rev 4 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 32KB(32b/l,2way) I-cache, 32KB(64b/l,4way) wr-back D-cache
cortex0 at mainbus0
ampintc0 at cortex0 nirq 160
agtimer0 at cortex0: tick rate 24000 KHz
sunxi0 at mainbus0
sxipio0 at sunxi0
sxiccmu0 at sunxi0
sxidog0 at sunxi0
sxirtc0 at sunxi0
sxiuart0 at sunxi0: console
sxiuart1 at sunxi0
sxiuart2 at sunxi0
sxiuart3 at sunxi0
sxiuart4 at sunxi0
sxiuart5 at sunxi0
sxiuart6 at sunxi0
sxiuart7 at sunxi0
sxie0 at sunxi0, address 02:99:03:c2:d2:6e
rgephy0 at sxie0 phy 0: RTL8169S/8110S/8211 PHY, rev. 5
rgephy1 at sxie0 phy 1: RTL8169S/8110S/8211 PHY, rev. 5
ahci0 at sunxi0 AHCI 1.1
scsibus0 at ahci0: 32 targets
ehci0 at sunxi0
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1
ehci1 at sunxi0
usb1 at ehci1: USB revision 2.0
uhub1 at usb1 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1
gpio0 at sxipio0: 18 pins
gpio1 at sxipio0: 24 pins
gpio2 at sxipio0: 25 pins
gpio3 at sxipio0: 28 pins
gpio4 at sxipio0: 12 pins
gpio5 at sxipio0: 6 pins
gpio6 at sxipio0: 12 pins
gpio7 at sxipio0: 28 pins
gpio8 at sxipio0: 22 pins
simplebus0 at mainbus0: "soc"
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
boot device: lookup 'sd0a:/bsd' failed.
root device:

-- 
SASANO Takayoshi <u...@mx5.nisiq.net>

Reply via email to