On Thu, Jul 23, 2015 at 09:13:08PM -0300, Daniel Bolgheroni wrote: > On Thu, Jul 23, 2015 at 05:54:50PM +1000, Jonathan Gray wrote: > > At the u-boot prompt try: > > > > printenv machid > > setenv machid 10bb > > Not yet. Somehow, this is related to U-Boot 2015.04, since I could boot with > 2014.04 (not -mainline). Didn't try yet with 2015.07 to see if things changed > yet.
You shouldn't have multiple phys attaching, it looks as though it isn't isolating the phy correctly. Though the sxie driver only attempts to support 'emac' not the 'gmac' found on your board. The device tables assume emac is present without probing, and it isn't clear if there is a way to do that without fdt. You could try setenv bootargs "sd0:/bsd.SUNXI.umg -c" boot and then do disable sxie* quit at the ukc prompt. > > Thank you. > > -- full log -- > U-Boot 2014.04-10733-gea1ac32 (Jan 27 2015 - 17:41:27) Allwinner Technology > > CPU: Allwinner A20 (SUN7I) > Board: Bananapi > I2C: ready > DRAM: 1 GiB > MMC: SUNXI SD/MMC: 0 > *** Warning - bad CRC, using default environment > > In: serial > Out: serial > Err: serial > Net: dwmac.1c50000 > Hit any key to stop autoboot: 0 > sun7i# > sun7i# > sun7i# > sun7i# fatload mmc 0:1 60000000 bsd.umg > reading bsd.umg > 4628832 bytes read in 253 ms (17.4 MiB/s) > sun7i# bootm 60000000 > ## Booting kernel from Legacy Image at 60000000 ... > Image Name: boot > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 4628768 Bytes = 4.4 MiB > Load Address: 40300000 > Entry Point: 40300000 > Verifying Checksum ... OK > Loading Kernel Image ... OK > > Starting kernel ... > > > OpenBSD/sunxi booting ... > arg0 0x0 arg1 0x10bb arg2 0x40000100 > atag core flags 0 pagesize 0 rootdev 0 > atag mem start 0x40000000 size 0x40000000 > bootfile: > bootargs: > memory size derived from u-boot > bootconf.mem[0].address = 40000000 pages 262144/0x40000000 > Allocating page tables > freestart = 0x4076b000, free_pages = 260245 (0x0003f895) > IRQ stack: p0x40799000 v0xc0799000 > ABT stack: p0x4079a000 v0xc079a000 > UND stack: p0x4079b000 v0xc079b000 > SVC stack: p0x4079c000 v0xc079c000 > Creating L1 page table at 0x4076c000 > Mapping kernel > Constructing L2 page tables > undefined page pmap [ using 391672 bytes of bsd ELF symbol table ] > board type: 4283 > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights reserved. > Copyright (c) 1995-2015 OpenBSD. All rights reserved. http://www.OpenBSD.org > > OpenBSD 5.8-beta (GENERIC) #182: Mon Jul 20 10:48:45 MDT 2015 > j...@imx.jsg.id.au:/usr/src/sys/arch/armv7/compile/GENERIC > real mem = 1073741824 (1024MB) > avail mem = 1044004864 (995MB) > warning: no entropy supplied by boot loader > mainbus0 at root > cortex0 at mainbus0 > ampintc0 at cortex0 nirq 160 > agtimer0 at cortex0: tick rate 24000 KHz > cpu0 at mainbus0: ARM Cortex A7 rev 4 (ARMv7 core) > cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled > cpu0: 32KB(32b/l,2way) I-cache, 32KB(64b/l,4way) wr-back D-cache > sunxi0 at mainbus0: Allwinner A20 > sxipio0 at sunxi0 > sxiccmu0 at sunxi0 > sxitimer0 at sunxi0: ticktimer 100hz @ 32KHz > sxitimer1 at sunxi0: stattimer 128hz @ 32KHz > sxitimer2 at sunxi0: cntrtimer @ 32KHz > sxidog0 at sunxi0 > sxirtc0 at sunxi0 > sxiuart0 at sunxi0: console > sxiuart1 at sunxi0 > sxiuart2 at sunxi0 > sxiuart3 at sunxi0 > sxiuart4 at sunxi0 > sxiuart5 at sunxi0 > sxiuart6 at sunxi0 > sxiuart7 at sunxi0 > sxie0 at sunxi0, address 02:96:0a:01:3c:5e > rgephy0 at sxie0 phy 0: RTL8169S/8110S/8211 PHY, rev. 5 > rgephy1 at sxie0 phy 1: RTL8169S/8110S/8211 PHY, rev. 5 > ahci0 at sunxi0 AHCI 1.1 > scsibus0 at ahci0: 32 targets > ehci0 at sunxi0 > usb0 at ehci0: USB revision 2.0 > uhub0 at usb0 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1 > ehci1 at sunxi0 > usb1 at ehci1: USB revision 2.0 > uhub1 at usb1 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1 > gpio0 at sxipio0: 18 pins > gpio1 at sxipio0: 24 pins > gpio2 at sxipio0: 25 pins > gpio3 at sxipio0: 28 pins > gpio4 at sxipio0: 12 pins > gpio5 at sxipio0: 6 pins > gpio6 at sxipio0: 12 pins > gpio7 at sxipio0: 28 pins > gpio8 at sxipio0: 22 pins > > -- > db >
