Hi, I'm trying to install OpenBSD on a Banana Pi board. So I dd'it the miniroot-sunxi-56.fs to the SD card and powered the board. This is all I get:
------- $ sudo cu -115200 /dev/cuaU0 Connected to /dev/cuaU0 (speed 115200) U-Boot SPL 2012.10-04277-g7aa9f04-dirty (Mar 28 2013 - 22:17:17) DRAM: 32MB ------- Two things comes to mind: and old U-Boot SPL version and the DRAM, which reports only 32 MB. I tried ArchLinux and it booted, so I can be sure it isn't a board problem: ------- $ sudo cu -115200 /dev/cuaU0 Connected to /dev/cuaU0 (speed 115200) U-Boot SPL 2014.04-10691-g493a12c (Jul 02 2014 - 15:02:40) Board: Bananapi DRAM: 1024 MiB CPU: 960000000Hz, AXI/AHB/APB: 3/2/2 spl: not an uImage at 1600 U-Boot 2014.04-10691-g493a12c (Jul 02 2014 - 15:02:40) Allwinner Technology CPU: Allwinner A20 (SUN7I) Board: Bananapi I2C: ready DRAM: 1 GiB MMC: SUNXI SD/MMC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: dwmac.1c50000 Hit any key to stop autoboot: 0 reading uEnv.txt 332 bytes read in 17 ms (18.6 KiB/s) Loaded environment from uEnv.txt Running uenvcmd ... reading script.bin 50936 bytes read in 29 ms (1.7 MiB/s) reading uImage 4801632 bytes read in 242 ms (18.9 MiB/s) ## Booting kernel from Legacy Image at 48000000 ... Image Name: Linux-3.4.90 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 4801568 Bytes = 4.6 MiB Load Address: 40008000 Entry Point: 40008000 Verifying Checksum ... OK Loading Kernel Image ... OK Starting kernel ... <6>Booting Linux on physical CPU 0 (...) ------- Any hints on this? Anything am I missing? Thank you. -- db
