Hi list,
I have a BeagleBoard xM and through a very helpful mailing list post I
set up a cross compiling toolset on i386 and got it to boot OpenBSD just
fine.
However the USB and the Ethernet port do not seem to work, and I did not
have a lot of luck getting them to work.
Are they supported and if so, what do I need to do to get them working?
Down below is the dmesg of the BeagleBoard xM.
Regards,
Florian
OpenBSD 5.4-current (GENERIC) #2: Thu Aug 22 12:33:26 MDT 2013
r...@noname.my.domain:/usr/src/sys/arch/beagle/compile/GENERIC
real mem = 536870912 (512MB)
avail mem = 519208960 (495MB)
mainbus0 at root
cpu0 at mainbus0: ARM Cortex A8 R3 rev 2 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 32KB(64b/l,4way) I-cache, 32KB(64b/l,4way) wr-back D-cache
omap0 at mainbus0: BeagleBoard
prcm0 at omap0 rev 1.0
intc0 at omap0 rev 4.0
gptimer0 at omap0 rev 1.3
gptimer1 at omap0 rev 1.3
omdog0 at omap0 rev 3.1
omgpio0 at omap0 omap3 rev 2.5
omgpio1 at omap0 omap3 rev 2.5
omgpio2 at omap0 omap3 rev 2.5
omgpio3 at omap0 omap3 rev 2.5
omgpio4 at omap0 omap3 rev 2.5
omgpio5 at omap0 omap3 rev 2.5
ommmc0 at omap0
sdmmc0 at ommmc0
com0 at omap0: ti16750, 64 byte fifo
com0: console
/dev/ksyms: Symbol table not valid.
scsibus0 at sdmmc0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <SD/MMC, Drive #01, > SCSI2 0/direct fixed
sd0: 15320MB, 512 bytes/sector, 31375360 sectors
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
boot device: lookup 'root=/dev/rsd0a' failed.
root device: sd0a
swap device (default sd0b):
root on sd0a swap on sd0b dump on sd0b
WARNING: CHECK AND RESET THE DATE!
