Am 2020-09-11 um 12:27 p.m. schrieb Mukul Joshi:
> SDMA utilization calculations are enabled/disabled by
> writing to SDMAx_PUB_DUMMY_REG2 register. Currently,
> enable this only for Arcturus.
>
> Signed-off-by: Mukul Joshi <mukul.jo...@amd.com>
> ---
> drivers/gpu/drm/amd/amdgpu/sdma_v4_0.c | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/drivers/gpu/drm/amd/amdgpu/sdma_v4_0.c
> b/drivers/gpu/drm/amd/amdgpu/sdma_v4_0.c
> index 856c50386c86..c764c27ba86d 100644
> --- a/drivers/gpu/drm/amd/amdgpu/sdma_v4_0.c
> +++ b/drivers/gpu/drm/amd/amdgpu/sdma_v4_0.c
> @@ -1063,6 +1063,16 @@ static void sdma_v4_0_ctx_switch_enable(struct
> amdgpu_device *adev, bool enable)
> WREG32_SDMA(i, mmSDMA0_PHASE2_QUANTUM, phase_quantum);
> }
> WREG32_SDMA(i, mmSDMA0_CNTL, f32_cntl);
> +
> + /*
> + * Enable SDMA utilization. Its only supported on
> + * Arcturus for the moment and firmware version 14
> + * and above.
> + */
> + if ((adev->asic_type == CHIP_ARCTURUS) &&
> + (adev->sdma.instance[i].fw_version > 13)) {
There are some redundant parentheses in the condition. The curly braces
are not needed for a single statement inside the "if". Also, write >=
14, that correlates better with the statement in the comment:
if (adev->asic_type == CHIP_ARCTURUS &&
adev->sdma.instance[i].fw_version >= 14)
WREG32_SDMA(i, mmSDMA0_PUB_DUMMY_REG2, enable);
If this feature is only available on Arcturus, we should make the
creation of the sysfs entries conditional as well. You can do that in a
follow-up change.
Regards,
Felix
> + WREG32_SDMA(i, mmSDMA0_PUB_DUMMY_REG2, enable);
> + }
> }
>
> }
_______________________________________________
amd-gfx mailing list
amd-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/amd-gfx
