From: Yongqiang Sun <yongqiang....@amd.com>
Program cursor attributes during set mode is only needed
in case of pipe slipt, bottom pipe should be programmed
same as top pipe. Need to program if address is 0.
Signed-off-by: Yongqiang Sun <yongqiang....@amd.com>
Reviewed-by: Tony Cheng <tony.ch...@amd.com>
Acked-by: Harry Wentland <harry.wentl...@amd.com>
---
drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c
b/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c
index 0d1f0e2a4350..c82d667c35a3 100644
--- a/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c
+++ b/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c
@@ -2436,7 +2436,8 @@ static void program_all_pipe_in_tree(
/* TODO: this is a hack w/a for switching from mpo to pipe
split */
dc_stream_set_cursor_position(pipe_ctx->stream, &position);
- dc_stream_set_cursor_attributes(pipe_ctx->stream,
+ if (pipe_ctx->stream->cursor_attributes.address.quad_part != 0)
+ dc_stream_set_cursor_attributes(pipe_ctx->stream,
&pipe_ctx->stream->cursor_attributes);
if (cur_pipe_ctx->plane_state != pipe_ctx->plane_state) {
--
2.14.1
_______________________________________________
amd-gfx mailing list
amd-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/amd-gfx
