Alle 11:35, giovedì 6 maggio 2004, Julien Claassen ha scritto:
> Hi!
> Did you try to use a simple dshare or something and then use bindings.
> It could look like that:
> pcm.my_40 {
> type dshare
> slave "hw:0,0"
> bindngs {
> 0 0
> 1 1
> 2 0
> 3 1
> }
> ipc_key 1738
> }
> I'm not sure about the bindings section. I don't know which channel to
> bind to which speaker and I don't know if it is bind channel to speaker or
> speaker to channel (3 1 or 1 3)? Perhaps it's worth a trial.
Thanks for your replay, but it doesn't work :(
I've tried different bindings:
1) 0 0
1 1
ok but i can't hear anything :(
2) 0 0
1 1
0 2
1 3
segmentation fault
3) 0 0
1 1
2 0
3 1
unable to route channels 0,2 to same destination 0
bye,
DarkBrain
> Kindest regards
> Julien
>
> --------
> Music was my first love and it will be my last (John Miles)
>
> ======== FIND MY WEB-PROJECT AT: ========
> http://ltsb.sourceforge.net - the Linux TextBased Studio guide
>
>
> -------------------------------------------------------
> This SF.Net email is sponsored by Sleepycat Software
> Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to
> deliver higher performing products faster, at low TCO.
> http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3
> _______________________________________________
> Alsa-user mailing list
> [EMAIL PROTECTED]
> https://lists.sourceforge.net/lists/listinfo/alsa-user
-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver
higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3
_______________________________________________
Alsa-user mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/alsa-user
