These are supposedly measurements from a wheelchair battery:

 

Resistance dropping as open circuit voltage increasing.  Maybe this guy can’t 
read his meter right.

 

 

 

From: ch...@go-mtc.com <ch...@go-mtc.com> 
Sent: Wednesday, June 07, 2023 3:13 PM
To: dmmoff...@gmail.com; 'AnimalFarm Microwave Users Group' <af@af.afmug.com>
Subject: Re: [AFMUG] battery overcharging

 

I guess that should be effective resistance is rising.  Got it backwards.  

 

 

 

From: dmmoff...@gmail.com <mailto:dmmoff...@gmail.com>  

Sent: Wednesday, June 7, 2023 1:07 PM

To: 'AnimalFarm Microwave Users Group' 

Cc: ch...@go-mtc.com <mailto:ch...@go-mtc.com>  

Subject: RE: [AFMUG] battery overcharging

 

I get what you’re saying.   Sounds like the worst outcome I can get is warm 
batteries.

 

Where I’m confused is I’m reading that resistance decreases as state of charge 
rises (and also decreases from heat).  If resistance is dropping, and we’re at 
a constant voltage, why is the current also dropping?  I’ve certainly seen a 
car battery charger do that, so it’s not that I’m disbelieving it, but what’s 
the mechanism causing it?

 

-Adam

 

 

From: AF <af-boun...@af.afmug.com <mailto:af-boun...@af.afmug.com> > On Behalf 
Of Chuck McCown via AF
Sent: Wednesday, June 07, 2023 2:03 PM
To: AnimalFarm Microwave Users Group <af@af.afmug.com <mailto:af@af.afmug.com> >
Cc: ch...@go-mtc.com <mailto:ch...@go-mtc.com> 
Subject: Re: [AFMUG] battery overcharging

 

Another metaphor would be inflating a tire to 32 lbs with the compressor 
pressure set to 32 lbs.  Once the tire is full the air will stop flowing.  

 

From: Forrest Christian (List Account) 

Sent: Wednesday, June 7, 2023 11:58 AM

To: AnimalFarm Microwave Users Group 

Subject: Re: [AFMUG] battery overcharging

 

Ignoring the overvoltage for a minute.. 

 

A normal battery,  when charged at a normal voltage, will take less and less 
current until full.   It doesn't matter how much current is available, it will 
only take what it needs.   Generally you want to limit the current based on the 
size of the array,  but that's for the start of charge, but the end of it.   
That is,  an empty battery array will take all the current you can give it,  
and too much can cause damage to the battery and maybe wiring. 

 

As far as the overvoltage goes, that's far more dangerous as overvoltages tend 
to cause "boiling" of the battery which is just another way to say that the 
battery is producing lots of hydrogen and oxygen which can cause explosive 
atmospheres around the battery, or in an extreme case can cause sulphuric acid 
steam to escape the battery.    Combine this with no overcurrent or time limit 
and at the bare minimum you should expect swollen and destroyed batteries. 

 

On Wed, Jun 7, 2023, 1:05 PM <dmmoff...@gmail.com <mailto:dmmoff...@gmail.com> 
> wrote:

So I was looking at a rectifier config and trying to imagine the worst possible 
thing I could do.

 

With some creativity I could start an equalizing charge that will run for 48 
hours at 58.5 Volts.  Normally it would stop when charge current hits a 
configurable fraction of the C10 Ah rating of the battery, but by intentionally 
misconfiguring the size of the battery and that fraction of Ah I could ensure 
that the equalizing charge runs until the maximum time limit…..which I can set 
as high as 48 hours.

 

I could also disable the battery current limit, disable the over temp shutoff, 
and disable the temperature compensation.  

 

If I’ve disabled the current limiting feature in the rectifier, what determines 
the current that will go into the battery when I’m on a constant voltage 
charge?  The charger can do up to 100A, but would it put 100A into the battery 
for the full 48 hours, or would some other factor limit it?

 

The spec sheet for the batteries lists an internal resistance of 3 milliohms.  
V=IR tells me they could take thousands of amps at 58.5V.  Is there any other 
limit here besides resistance.  If nothing else stops this machine from dumping 
it’s full 100A into the batteries for 48 hours I’m pretty sure I could start a 
fire or explosion with this rectifier if I wanted to. I’m not trying to commit 
an act of sabotage by the way, I’m just wondering if a creative idiot could do 
something terrible.

 

 

-- 
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com> 
 <http://af.afmug.com/mailman/listinfo/af_af.afmug.com> 
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

  _____  

-- 
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com> 
 <http://af.afmug.com/mailman/listinfo/af_af.afmug.com> 
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

-- 
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

Reply via email to