Cutting of the metal tabs with something like an angle grinder with a cut-off wheel in it would probably work pretty well. I think I used a 3" cut-off tool last time, which didn't work too badly. I've tried just bending them out of the way, but that causes problems.
It really annoys me, because all they would've needed to do is shift those tabs over like 1/8" and it would've worked just fine either way. It almost looks like they intentionally designed it to be able to flip over, and then changed it slightly so it couldn't. On Thu, Nov 4, 2021 at 4:28 PM Steve Jones <thatoneguyst...@gmail.com> wrote: > You find a good way to grind out the punch? I didnt have an angle grinder > with me just a bench grinder, took forever and is rough. > > Its irritating because the punch is a viewing window for the LEDs and the > pins are set for rotation. But then a second engineer designer smoked crack > and finished up the design > > On Thu, Nov 4, 2021, 4:14 PM Mathew Howard <mhoward...@gmail.com> wrote: > >> been there, done that... >> >> On Thu, Nov 4, 2021 at 4:11 PM Steve Jones <thatoneguyst...@gmail.com> >> wrote: >> >>> -- >>> AF mailing list >>> AF@af.afmug.com >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
