If I were getting another one I think I'd probably do a Fujikura 41s. My 18s has been very dependable.
On Tuesday, October 6, 2020, <ch...@wbmfg.com> wrote: > I have a couple View 5s that I like. Still there are splicers out there > that are half the price of a View 1. But you get what you pay for. > > *From:* Mark - Myakka Technologies > *Sent:* Tuesday, October 6, 2020 12:18 PM > *To:* AnimalFarm Microwave Users Group > *Subject:* Re: [AFMUG] drop splicers > > Chuck, > > We have been using this one just for doing splicing at the house. We also > use the splice on ends. > > > https://www.innoinstrument.com/eng/product/fusionsplicer1.asp > > https://www.balticnetworks.com/fiber/splice-on- > connectors/inno-instrument-sc-single-mode-apc-0-9mm-splice- > on-connectors-50-pack > > -- > Best regards, > Mark mailto:m...@mailmt.com > > Myakka Technologies, Inc. > www.Myakka.com > > ------ > > Tuesday, October 6, 2020, 12:31:54 PM, you wrote: > > > A while back there was a discussion about hand held fusion splicers for > drops. I don’t want to send my larger active core alignment splicers out > with drop crews. > > Cannot find the thread. There were some suggestions about lower cost > fusion splicers that people like. Love to hear those suggestions again. > > ------------------------------ > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
