What's up with the 900 Mhz and latest firmware?
On 06/21/2018 11:01 PM, Timothy Steele wrote:
Sounds like interference issue latest firmware is very solid unless your
running 900mhz
On Thu, Jun 21, 2018, 5:22 PM Jason McKemie
<[email protected]
<mailto:[email protected]>> wrote:
I'm having a bit of a head-scratcher here. I've got a Ubiquiti
Nanostation that I'm using as an AP for a small repeater site. All
of the CPE's attached to it dropped in TX signal strength by about
15-20db. I tried switching the Nanostation out thinking maybe it
was going deaf, but the problem persisted. Then I tried switching
to the opposite end of the band (was at the low end). Problem went
away. Is there something I'm not aware of from a regulatory
standpoint that has been added in newer firmware or is this a bug?
It didn't seem to have nearly as much of an effect on the AP's TX,
so I'm leaning towards a bug.
-Jason
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
