Hi Robert, I think that -incremental and –deletefiles are not available (or ignored) with -imagetofile. It makes sense since -incremental would lead to a file restore whereas -imagetofile leads to a bloc restore.
You should note that –deletefiles is not availbale (or ignored) if your backup has been done like you do : backup image F: -mode=incremental -- Best regards / Cordialement / مع تحياتي Erwann SIMON ----- Mail original ----- De: "Robert Ouzen" <rou...@univ.haifa.ac.il> À: ADSM-L@VM.MARIST.EDU Envoyé: Mercredi 17 Juin 2015 11:57:18 Objet: Re: [ADSM-L] Backup and restore question Hello Ronald Make sense …. But still I made today a little test 1. Run a backup image F: (Full) (On it I have there a file test.txt with content: “First full backup Image”) 2. Edit this file test.txt and overwrite with “Incremental backup image” 3.: run a backup image F: -mode=incremental See below the output (seems good) tsm> backup image f: -mode=incremental Total number of objects inspected: 16 Total number of objects backed up: 1 Total number of objects updated: 0 Total number of objects rebound: 0 Total number of objects deleted: 0 Total number of objects expired: 0 Total number of objects failed: 0 Total number of objects encrypted: 0 Total number of objects grew: 0 Total number of retries: 0 Total number of bytes inspected: 41.51 KB Total number of bytes transferred: 240 B Data transfer time: 0.00 sec Network data transfer rate: 0.00 KB/sec Aggregate data transfer rate: 0.03 KB/sec Objects compressed by: 0% Total data reduction ratio: 99.44% Elapsed processing time: 00:00:07 4. did an: restore image F: E:\DiskF.iso –imagetofile -incremental –deletefiles 5.But on the file DiskF.iso I see on the test.txt file the content of: “First full backup Image” and not “Incremental backup image” I know I missed something but I can’t figure WHAT ??? Best Regards Robert From: ADSM: Dist Stor Manager [mailto:ADSM-L@VM.MARIST.EDU] On Behalf Of Ron Delaware Sent: Wednesday, June 17, 2015 9:34 AM To: ADSM-L@VM.MARIST.EDU Subject: Re: [ADSM-L] Backup and restore question Robert, You cannot perform a normal incremental once you have performed a full image, unless you have two separate nodes, one doing image backups and one doing file by file backups. You can do incremental image backups but not an file by file incremental. Best Regards,
